Conceptronic C150APRA2 Manual do Utilizador descarregar pdf (Página 23)

CONCEPTRONIC C150APRA2 ENGLISH

The following table describes the parameters in this page.

ATM PVC CONFIGURATION

Field

Description

VPI

Virtual Path Identifier (VPI) is the virtual path between two points

in an ATM network. Its value range is from 0 to 255.

VCI

Virtual Channel Identifier (VCI) is the virtual channel between two

points in an ATM network. Its value range is from 32 to 65535 (0 to

31 is reserved for local management of ATM traffic).

Service Category

Select UBR with PCR, UBR without PCR, CBR, Non Realtime VBR,

or Realtime VBR from the drop-down list.

Peak Cell Rate

Set the maximum transmission rate of the cell in ATM transmission.

Sustainable Cell Rate

Set the minimum transmission rate of the cell in ATM transmission.

Maximum Burst Size

Set the maximum burst size of the cell in ATM transmission.

CONNECTION TYPE

Field

Description

Protocol

Select PPP over ATM (PPPoA), PPP over Ethernet (PPPoE), MAC

Encryption Routing (MER), IP over ATM (IPoA), or Bridging from

the drop-down list.

Encapsulation Mode

Select LLC or VCMUX from the drop-down list. Usually, you can

select LLC.

802.1Q VLAN ID

If you enter a value, packets from the interface is tagged with the

set 802.1q VLAN ID. Its value range is 0-4094, while 0 indicates to

disable this function.

NETWORK ADDRESS TRANSLATION SETTINGS

Field

Description

Enable Bridge Service

Select or deselect the check box to enable or disable the WAN

connection.

Service Name

The name to identify the WAN connection. You need not modify it.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 110 111

Comentários a estes Manuais

Sem comentários

Conceptronic C150APRA2 Manual do Utilizador Página 23

Comentários a estes Manuais

Manuais e produtos relacionados com Pontos de acesso WLAN Conceptronic C150APRA2